need help

Status
Not open for further replies.

dtran

Full Member
Oct 24, 2010
8
0
san diego
So I just got the riva 901 after seein vid and how good it look I went out to buy one I mainly got it so I can just use it for dripping so I took it home put everything together and put a drip tip on top put about 3 or 4 drip in and started smoking but didn't get good vapor not much at all then the atomizer got so hot is that normal or did I just fried my atomizer then I taste a burnt taste I need help on how you smoke this e cig with the dripping form is there a certin way I'm inhaling do I have the wrong atomizer plase anyone I need help and answer
 

deback

Ultra Member
ECF Veteran
Sep 25, 2010
2,054
16
Michigan
If you're dripping into the atomizer using a drip tip, you'll need to drip 3 drops into it after about 6 to 10 drags (also called, puffs or vapes). The number of vapes will vary, depending on how long you puff on it each time. Some people have posted 8 to 10 vapes, others have posted 6 to 8 vapes -- per every 3 drips into the drip tip. However, it would seem that some of the juice will remain in the drip tip, so you might need to drip more than 3 drops into the drip tip.

When you get a burnt taste, it means the atomizer is dry and needs more liquid.

When the atomizer gets too hot, it means it's too dry and needs more liquid.

If you continue to try to vape a dry atomizer, the atomizer will burn out and will no longer work.

If your juice has VG in it (vegetable glycerine), you should be getting good vapor, as long as you keep the atomizer wet with liquid.

If you get tired of dripping into the drip tip/atomizer, you could try a cartomizer, which is a one-piece cartridge with a built-in atomizer and filter. When filling blank cartomizers, you just drip about 18 to 20 drops directly into the filter, after removing the mouth end white cap, while holding the cartomizer at a 45-degree angle. When refilling cartomizers, drip 10 to 12 drops into the filter. If you drip more than that into the filter, it will overfill it, and the result will be less vapor, harder to puff, and a need to blow through the threaded end of the cartomizer into a tissue to remove the excess juice.

If you do decide to switch to cartomizers, you'll probably see recommendations to use the "condom" method to refill them. This is more time-consuming and is more messy than directly dripping into the filter. With the direct drip method, you just remove the white mouth cap, drip, put the mouth cap back on, and vape. There's no mess to clean up and no chance of overfilling the carto, if you only drip about 10 drops into the filter (drip no more than 12 drops, and that could be too many, if you didn't vape the carto until you got the burnt taste, which would be too long, since the burnt taste means the atomizer is burning the filter).
 
Last edited:

jj2

Moved On
ECF Veteran
May 30, 2009
196,879
212,800
Hundred Acre Wood
Sometimes it takes more than a few drops to get the atty going, so add a few more. Take a couple drags (don't inhale). If there is still nothing, add a couple more.
Still nothing. Take off the atty and blow hard through the end that screws into the battery a few times. Do this over a paper towel.
Screw back on and take a couple of puffs.
 
Status
Not open for further replies.

Users who are viewing this thread