NEED HELP

Status
Not open for further replies.

EZGOER

Full Member
Verified Member
Dec 2, 2015
49
21
63
Hello everyone I'm Frank with another newbie question. What causes the cotton to come out the top of my coil? Let me add some info. I'm using 0.3 ohm Ni coil in a Delta II tank. This tank and coil are on my eLeaf istick tc 40w box, using this in temperature control mode at about 450 degrees f. This coil has been in my tank for only 2 or 3 days, and this is the second Ni coil I've used. The first coil did not do this. Am I doing something wrong? Is this a defective coil? Please help.

Thanks again,
Frank
 

EZGOER

Full Member
Verified Member
Dec 2, 2015
49
21
63
Thanks for replying so fast TheMike21. Sorry I don't have a picture, but I will try to describe what's going on. When I remove the base of my tank to refill it, you can see down through the top of the coil. As you know the coil is screwed into the base. Anyway when I look through the little hole at the top of the coil I can see a circular mesh screen covering the cotton and a few strands of cotton are coming up through this hole and above the mesh screen. The cotton does not come all the way out, it's like laying on top the screen. I have been using this tank and box combo for about a year and have never seen this before, although like I said I just recently started using the Ni coils.

Thanks again,
Frank
 
Status
Not open for further replies.

Users who are viewing this thread