need help

[Eric61]

Hi everyone.Im trying to bring new life in my old reo and am curious what ohm range you use on your rda coils and what nicotine strength you use.Thanks.

 

[bombastinator]

Well I don’t squonk so I’m not sure how valuable my opinion will be. I’m sort of halfway between a MTL vaper and a big cloud guy. I like to vape single coils at around .5 ohm. 6 wraps of 22ga kanthal on a 3.5mm mandrel should do that. 2 coils just like that and you’ve got a pretty puffy rig, lower the wire gauge to 26ga and you have a kind of metal rig. I vape 12mg which is pretty strong for a cloud rig. Or many people who take a puff off my vape for that matter

 

[gpjoe]

I use Origen Little 16 clones on my Reo Grands. I build them with a 5-wrap single coil between the posts using 28-ga kanthal, 5 or 6 wraps at 2.5-mm. Not sure what the resistance is, but I'm guessing around an ohm, give or take.

I used the Little 16 with the dual airflow set to the largest openings and get a restricted direct lung hit.

Battery life is pretty darn good with the smaller gauge wire, and vapor production is satisfying - not huge clouds, but good enough for me. If you want more vapor and warmth you could try the same coil with 26-ga kanthal, which would lower the resistance and give you more wire mass, but shorter battery life.

 

[Eric61]

I have a original reo will I be able to use a 22mm or 24mm aty and if not can I use a adapter to get it past the lip of the juice well.

 

[zoiDman]

Hi everyone.Im trying to bring new life in my old reo and am curious what ohm range you use on your rda coils and what nicotine strength you use.Thanks.

I'm not a REO user.

But for a Single Battery Mech Squonker, I like to use a 26ga SS 0.35 Ohms 3mm Single Coil in a NarDa RDA.

All my Squonkers have 9mg/ml Unflavored in their bottles. And I do Flavored Wicks when do a New build. And occasionally to give them a Flavor Boost.

 

[gpjoe]

I have a original reo will I be able to use a 22mm or 24mm aty and if not can I use a adapter to get it past the lip of the juice well.

The original Reo Grand will only accept smaller diameter RDAs (14mm?). A 510 adapter with a hole in the center would work but the RDA will sit way above the mod.

Otherwise you will need a Low Profile (LP) Grand or a P67.

 

[puffon]

...or send it in to REOs Mods for milling down, or DIY.

 

[rob33]

I still have my REO 14mm it's a classic, to change it up would be like putting square headlights on a 1950s Cadillac