need to get over 1 ohm on my v4 orchid

[Jeremy Taylor]

I have two orchids, a kayfun and a Lemo on the way. However I just bought an eleaf for an everyday carry and I need to ohm over 1.0 on it. What would be the best build to accomplish this on one of my orchids? Dual coils kind of makes it hard.

 

[Sthur]

Hello and welcome, well if you can try 30 guage about 9/10 wraps around a 5/64 or 1/16 bit and should be 2.0-2.2 ohms and 1ohm total for both coils.

Hope this helps.

 

[KenD]

What wire gauge are you using? What coil diameter? 12 wraps with 28 ga, 2.4 mm diameter, should put you at about 1.2 ohms. With 30 ga at the same diameter you'll reach 1.2 ohms with 8 wraps. You can try different combinations at steam-engine.org