Hey all,
I searched for this question and wasn't able to find an answer so I apologize if this is covered elsewhere. I have been using a Nemesis Clone mech mod for a few months now and overall I am satisfied with it. I am having a few issues with the switch, however, and hoped that someone could help me out.
I carry my Nemesis with a Taifun GT in my pocket at work (yes I have large pockets
) and I have had two ongoing issues with the switch. The first issue is that the switch likes to work it's way loose and extend the throw. This may be a mistake on my part of how I set it up. This is what I do: I screw in the switch until its tight and check the throw. If it is too long or too short I take it out and adjust the center pin. Once I get it to where the full throw stops just short of hitting the locking ring with the locking ring all the way in, I screw the switch in until it's tight. When I lock it I just screw the locking ring down until it's against the switch. I try not to over-tighten the locking ring because it can be hard to undo. Most days I have to adjust the throw a few times because it works it's way out until the throw is too long and the switch gets all crunchy.
The second Issue I am having may be related to the first, but I have had several times where I know I screwed out the locking ring but I'll feel my pocket getting hot and I'll reach in and the mod's been firing. This usually results in a slight burn on my fingers and juice in my pocket. The first issue I can live with but this is dangerous. Any suggestions on how I can fix this, or on another inexpensive mod that won't have this issue?
Sorry I know it's a long post but I've tried to answer any questions you might have up front.
Thanks in advance!
I searched for this question and wasn't able to find an answer so I apologize if this is covered elsewhere. I have been using a Nemesis Clone mech mod for a few months now and overall I am satisfied with it. I am having a few issues with the switch, however, and hoped that someone could help me out.
I carry my Nemesis with a Taifun GT in my pocket at work (yes I have large pockets
) and I have had two ongoing issues with the switch. The first issue is that the switch likes to work it's way loose and extend the throw. This may be a mistake on my part of how I set it up. This is what I do: I screw in the switch until its tight and check the throw. If it is too long or too short I take it out and adjust the center pin. Once I get it to where the full throw stops just short of hitting the locking ring with the locking ring all the way in, I screw the switch in until it's tight. When I lock it I just screw the locking ring down until it's against the switch. I try not to over-tighten the locking ring because it can be hard to undo. Most days I have to adjust the throw a few times because it works it's way out until the throw is too long and the switch gets all crunchy.The second Issue I am having may be related to the first, but I have had several times where I know I screwed out the locking ring but I'll feel my pocket getting hot and I'll reach in and the mod's been firing. This usually results in a slight burn on my fingers and juice in my pocket. The first issue I can live with but this is dangerous. Any suggestions on how I can fix this, or on another inexpensive mod that won't have this issue?
Sorry I know it's a long post but I've tried to answer any questions you might have up front.
Thanks in advance!
