New here. This is my gear. I want better vapor clouds, more throat hit....steer me right>

Status
Not open for further replies.

theoctavist

Full Member
Oct 14, 2013
8
2
SE NC
Currently have two smoktech winder batteries, a smoktech trophy tank, and a couple of rebuildable clear tanks.

i like mysetup...but I want better vapor clouds..bigger and a better throat hit. i use the highest nicotine strentgh juice. noticing that it is typically 60/40.

I basically want the best there is. want something that will last give great vapor clouds/production and sometjhing rebuildable.

i am willing to buy everything from scratch again. i went with the winder setup because i was new to it and it seemed like the way to go for a newbie. but now i want more vapor , more throat hit..more everything.

it is my birthday coming up, what should I ask for?

i am from NC. Army Veteran OIF/OEF. Writer. Government Agency drone. VoiceOver hack. Musicophile, audio geek, and recording and audiophile gear fanatic. two little girls, and two stepsons.
 
Last edited:

Jazzi Mike

Ultra Member
ECF Veteran
Verified Member
Jun 3, 2013
1,566
853
Michigan
You don't need a mech to rebuild. That is actually bad advice for someone that has just started RBAs. You should definitely start with a dripper. They are probably the easiest to start out with, plus the vape will probably be on the level with what you are looking for.

Once you get more apt at rebuilding, maybe mechs or subohm will be up your alley. Either way, it is not something to start with!
 

yaypudding

Super Member
ECF Veteran
Verified Member
Jul 17, 2013
809
2,422
North of NYC
Granted you don't need a mech to drip. I use my vamo with an igo-l with a 1.6ohm micro coil.

You will need something to measure your ohm's with, a multi-meter or a regulated device like a vamo or svd will work.

If you have one of those first, then go the mech route, but w/o a proper way to measure the ohm's of your coil a mech can be dangerous territory, especially if your new to rda's - rba's.

rebuildables are def. the way to go for increasing flavor, vapor and TH. Plus they're cheaper over the long run.
 

Cr0tchF4i

Senior Member
ECF Veteran
Verified Member
Jul 25, 2013
247
189
San Diego, CA
You don't need a mech to rebuild. That is actually bad advice for someone that has just started RBAs. You should definitely start with a dripper. They are probably the easiest to start out with, plus the vape will probably be on the level with what you are looking for.

Once you get more apt at rebuilding, maybe mechs or subohm will be up your alley. Either way, it is not something to start with!

Good point- I guess I was under the impression the proper research would be done prior to purchase and building. I'm a trial and error guy but always pick up some knowledge first.
 
Status
Not open for further replies.

Users who are viewing this thread