new to the fourm but not to vapeing

[megna22]

Hi everyone! just wanted to say that I've been vapeing since December 2013 and haven't looked back still smoke free and have learned alot off fourms and on u-tube thank god for u-tube. Anyway I am still looking for a good tank that is consistant so far its been the kayfun fantastic tank!! Still haveing son trouble with makeing coils tho it usually takes me 3 or 4 tries to get it right. The problem I have is when I try to attach the coil to the deck I usually wind up screwing up the coil and starting over I just wish I could find a kayfun like tank that you put the wire through holes instead of wrapping it around screws. O-well the price we pay for not smokeing cigarettes I guess.

 

[Mrdaputer]

Welcome the Aspire mini is a good tank or the bigger Aspire Nautilus they both use the bvc coils. What battery do you use? The mvp2 is a good one or a nice back up too.

 

[Susan~S]

Hello and welcome to the forum megna22. Glad to have you here!

 

[DarkEgo]

Do you wrap micro coils or do you wrap the coil around your wick? If you are building micro coils then leave the coil on your drill bit (or w/e you use) so that you can position your coil. First wrap your leg a half turn or so around your first post, tighten down, align the coil then wrap around second post and tighten down. That's the method that works best for me anyway.

 

[eratikmind]

Do you wrap micro coils or do you wrap the coil around your wick? If you are building micro coils then leave the coil on your drill bit (or w/e you use) so that you can position your coil. First wrap your leg a half turn or so around your first post, tighten down, align the coil then wrap around second post and tighten down. That's the method that works best for me anyway.

For me, this is has worked well for all of my RBAs.

 

[megna22]

Thanks I'll have to check out that one

 

[megna22]

No I usually use a screwdriver or a coil jig

Do you wrap micro coils or do you wrap the coil around your wick? If you are building micro coils then leave the coil on your drill bit (or w/e you use) so that you can position your coil. First wrap your leg a half turn or so around your first post, tighten down, align the coil then wrap around second post and tighten down. That's the method that works best for me anyway.