You can refill them with autos. You jsut have to be more careful about not letting one leak onto the end of the battery. Autos are much easier to damage or kill with juice leaks. Get a manual though to see how it gives you more control of your hit etc. On the manual you can also use a standard resistance DSE901 atomizer w/ a drip tip (LiteCigUSA.net has these) and if the drip tip is one of their plastic or delrin 510/901/KR808D-1 ones then you should be able to use it as a comfortable mouthpiece in place of a cartomizer endcap too (easy to remove to add juice).
--
How I fill a cartomizer (Vapor4Life for KR8 or Boge 510 for 510 which are all soft-cap w/ no inner seals and defined central air channel)
I use thin (20% or less VG) liquid or Vapor4Life WOW liquids, preferably clear liquids w/ no sediment. This soak in more easily and wick well, and the clear ones leak the stuffing as white as they found it and don't clog it up.
Filling a blank carto - I pop off the soft cap (unbent paperclip carefully in the mouth hole, not catching any wires or stuffing!). I hold some tissue against the threaded end hole. I tilt the carto and slowly drip 18 drops (per ml of carto capacity and these are 1ml cartos) onto the inner wall of the carto so it slides down into the stuffing while I rotate the carto. Then I wait 15 seconds or so then I drip however many more drops the stuffing wants to soak up. Then I do clean-up. If it is leaking, I clean that up. Then I tilt the open end down into the tissue and puff a couple of times into the threaded end to clear any juice out of the central air channel (I want to see light through there). If it looks too wet above the stuffing, I gently touch a bit of tissue to the stuffing (otherwise that liquid will be leaking or gurgling or spitting in my mouth). Then since this was a fresh fill of a blank, I now let it settle. I lay the carto on different sides for 15-20 minutes. Then it should be ready to vape. If you use thicker juices than me, then you may need to let it settle longer.
As I am vaping - if the vapor gets a bit light or a bit dry or tastes bit off or the carto is getting unusually warm, I will take the carto off the battery, open it, add 6-8 drops or whatever it seems to want (I will either hold a bit of tissue against the threaded end hole just in case, or skimp on how many drops I add to make sure I avoid drips if I have no tissue). I check to make sure the threaded end is dry, give it a couple of puffs into the threaded end to make sure the air channel is clear, and continue to vape.
Note - it is easy for me to "open" my main cartos for adding juice because I replace the white end cap with a plastic or delrin drip tip (I get them at LiteCigUSA.net). So I can easily pull that out with my fingers when I add juice and it keeps my lips cool if the carto is hot.
