New User on Innokin MVP

[dhdaniel]

Hello, New guy here. Been using an Ego twist for a while, Just acquired a new MVP.
I learned well the art of tweaking the voltage to fine tune the juice & clearomizer.
When it started to taste burnt, I just backed it off a hair.

I own about 12 Aspire ET-s glass tanks and 2 Mini Protanks I have several juices I like, 50/50 blend I think

This new MVP is pretty cool, I really like it, My question is the wattage adjustment?
using the mentioned tanks with 1.8 ohm coils, How do I utilize the variable wattage feature?

thanks for any help. This forum looks healthy, tons of info, OVERLOAD!

Dave

 

[StrafeMalone]

I have found that if you do not drill out the air Holes on the ET-S then 6.5 watts is good.
I drilled out one hole on both of the ET-S tanks I have to 1/8th inch and set my wattage to 7, vapes near perfect for my tastes!

*edit* I forgot to say that I use a MVP as well.

 

[PaulBHC]

You can set watts or volts but not both. If you set watts, it will calculate volts based on the ohms of the coil. Which ever button you press last is what you are using.

 

[CreepyLady]

You would use watts the same way that you use volts, When you press and hold 'P' as opposed to using 'U' you will enter watts mode. Just remember you use watts OR volts, you cannot set both, when you use watts the MVP will automatically adjust voltage should you switch to a tank with different resistance.

You are operating in whichever you push last, P is watts U is volts.

 

[Jscheiben]

Welcome to the forum. To adjust wattage hold down the "p" button, will first show the number of puffs then it'll switch to wattage mode. Can increase wattage by .5 each press of the "p" button to a max of 11w.

 

[phoenixbwp]

As stated by the others, on getting into the settings for VW, hold the P button. Best and worse case on what setting to use, start with 6 and try up to 8. Using wattage mode, the MVP will check the ohm of the coil and set the volts accordingly and automatically, even if you swap out clearomizers. one being at 1.8 another at 2.2, the volts will be calculated via the watts you set on the MVP. VW mode, you have to always tweak volts to avoid dry hits or burnt hits...