innokin iTaste MVP 2600mah VV/VW 20W
$47.95
Introducing the newest innokin iTaste MVP - The MVP 20W VV/VW! This can go from 6.0 to 20 watts! One of the greatest improvements over the MVP 2.0 is a spring-loaded positive pin for increased connectivity. Any accessories (skins or cases) designed for the MVP 2.0 will also fit the MVP 20W, as the dimensions are identical.
Shares many features of MVP 2.0，but also including:
- Variable Wattage: Wattage can be adjusted from 6.0 to 20.0 Watts in 0.5 watts increments, improvement in this MVP body
- Variable Voltage: Voltage can be adjusted from 3.3 to 7.5 volts in 0.1 volt increments
- Large battery capacity: 2600 mah
- ON/OFF battery switch
- 10 second cutoff protection.
- Low Voltage Warning
- Short Circuit/Atomizer Protection
- Over Discharge Protection
- Battery Level Indicator
- Ohms meter; puff counter
- Remembers last voltage or Wattage setting
- Has an output USB port for providing power to other portable electronics (such as emergency power for your phone!)
The iTaste MVP battery capacity is displayed via green, yellow and red LED lights.
Green = Fully Charged
Yellow = Half Discharged
Red = In need of charging
- Dimensions: 22mm by 41mm by 107mm
- Threading: 510/eGo (comes with an eGo adapter)
- Capacity: 2600mAh
- Package: Crystal Box with excellent manual and additional Innokin logo appliques you can dress your MVP up with.
What You Receive:
- iTaste MVP 20W Box Mod
- 40 inch Micro USB Charging Cable
- 510 to eGo adapter
- Crystal Gift Box
Quick Instructions
- Power On/Off - 3 clicks of the power button within 1.5 seconds cycles the power on/off.
- Change Wattage - Pressing and holding the "P" button will first display the puff counter then engage power mode; subsequent clicks increase the wattage in 0.5W increments until 20.0W, then cycles back to 6.0W.
- Change Voltage - Pressing and holding the "U" button will first display the puff counter then engage voltage mode; subsequent clicks increase the voltage in 0.1V increments until 7.5V, then cycles back to 3.3V.
- Atomizer Resistance and Battery Voltage - Pressing both the "P" and "U" buttons together will cause the screen to display the atomizer resistance, followed by the battery voltage. If there is no atomizer detected, the device will display "NON."
