Next step - mechanical?

[IrishUpstart]

Looking to add to my mechanical collection, which presently consists of 1...a k100 clone from fasttech. Loving the experience thus far. Just curious what the next logical step would be for my next one in terms of price/quality?

 

[Royaldrunker]

Whats your price range?

Chinese clones? Limit runs or and i add this because they are made the best Philippines

For $130 you can get a top mod... The sioux made in Philippines and compared equal to the nemesis with very little voltage drop..aluminum/copper. Silver contacts floating/adjustable

I have one and its beautiful and rocks

That being said you can spend $60 on a clone or 200 plus on a limited run

 

[michliu]

I had a K101 and they hit pretty hard. If you want the same performance from a Chinese clone, the KTS and Chentinel are up there. For even better quality, though it comes with a price, the EHPro EA clone is excellent, as are other EHPro mechs. I have had four, the EA, Bagua, Nzonic, and MKB-TS clones from EHPro, and they all are built well and perform excellently.

 

[IrishUpstart]

Groovy! I will start checking all the suggestions out.

As for price? Between 22 and a 100. Lol

 

[vapo jam]

i haven't yet tried one (or even seen one in person), but i've heard a lot of good things about the magneto. my opinion probably isn't the best, though - i personally went pretty high-end after my k100...

i would recommend trying out at least one high-end mech at some point, though, even if not right now. if you decide that it's not for you, you can usually sell it and get most of your money back.

 

[Statistic]

Buy a REO Grand and a Reomizer 2.0 and you'll never pick up another tube mod again.

 

[IrishUpstart]

Buy a REO Grand and a Reomizer 2.0 and you'll never pick up another tube mod again.

I do want one really bad...lol