Hey all, here is my first mod. I am getting no power. Can someone advise me? I can provide further explanation if needed. Thanks!
- Status
Well 1st thing i would it with the battery in (You need a multimeter) is check power to the switch on the wire that comes from the pos battery terminal. The wire looks like is could interfere with the connection. sometimes the batteries wont make contact with the nub on the terminal. If that checks out then check for power through the switch, then at the atty. Try that and post back.
Hi! I checked with the multimeter, and there does not seem to be any voltage. Batteries have 1.33v.
1.33v is pretty much a dead battery....charge it. Then retest and be specific as to where you are not getting power, go to switch first, then output from switch with button pressed, then atty, and report back.
I originally made a passthrough MOD, which was working great, but it stopped working. The connector that I used was a Size N coaxial DC jack w/ switch 274-1583 or similar. Is MadVapes the only place that sell a proper atty connector, or else use one from a dead atty? I don't really want buy more parts, as I only wanted to build a couple MODS for back up.
Ok, I am a total newbie and dolt. I am just realizing that the battery should be at least 3.6v. Okay... I better re-read the A-B-C's of batteries again!!!
I prefer buying the right parts for the job....after all, the objective is making it right so it works right.
This one works best for me
Great, thanks Parallex2. I will have to wait until next month to buy parts. I already spent my allottment for this month. LOL!!!
- Status
