Nimbus making THIN and HARSH vapor

Status
Not open for further replies.

Lessifer

Vaping Master
ECF Veteran
Verified Member
Feb 5, 2013
8,309
28,986
Sacramento, California
Okay everyone, I'm sorry about the delay. Here are the pics of the coils Ive made that did work, but just worked awfully. Thank you and I look forward to everyones assistance, and hopefully I can get the help I need and improve this thing so that it works like it should!

As of now, its basically impossible to vape from. The amount of vapor is so small and thin, and it is too harsh to vape.

From what I can see, your coils are at 12 and 7 on a clock face, you need them to be directly opposite eachother 12 and 6 so that each air hole hits a coil. Also, you need your coil to be vertically aligned with the air hole. You also seem to have a crazy number of wraps in there, but it's hard to tell with the focus. Have you tried running a single coil and getting that working well?
 

ruet

Super Member
ECF Veteran
Verified Member
Apr 20, 2011
553
1,118
GR, MI
Here's the pic of my current build.

_20140422_000258.jpg

Not my best coil as it was a bit of a rush job. Vapes like a dream though. As an aside; when I started with my Kayfuns I used cotton yarn for my wicking material. The yarn did not wick consistently. Once I switched to cotton balls all was well in the world. Later, when I received my Nimbus (clone), I started out with cotton balls. The wick from the cotton balls could not keep up in the Nimbus so I switched back to cotton yarn. Again, all is well in the world. Go figure... :blink:
 
Status
Not open for further replies.

Users who are viewing this thread