I am probably to late but to address a few issues,
Gurgling sound is to much liquid in the atty(A little is Ok but not to much). Remove and blow through the threaded end hold paper towel up close to the end. Repeat until it is clear, also you can leave overnight on paper towel big hole down to drain.
Cleaning, it self cleans every so often and has a burnt sulfur taste but six or eight puffs usually clears it up after primer is gone. you can remove the cart and blow through the LED end for 4-6 seconds, you will see a little smoke come out the end. Do not over do this, to long and it will burn the atty up. After a while the smoke will decrease until it is very noticeable if the burn clean approach does not satisfy you soak in Coke or Dr Pepper for two hours, rinse throughly with water blowing a few mouthfuls through both ends. Blow dry through little hole until no more wet sound. Attach to a paper clip and use a blow dryer for several minutes. Use a damp paper towel to remove from clip and cool down. It will need at least two drops of primer now and a full cart.
juice gets through into mouth. remove the cart with paper clip wipe the cart off. Using damp paper towel twist inside of cart until it reaches the bottom and throw away the little round fiber inside the tube. Reassemble and draw slowly. There are two different type atty that N-Joy sends out, new ones in plastic and others. Some have bigger holes on the threaded side and allow a much easier draw some are small hole that a paper clip will not even go through. The smaller need a very light pull or it will suck juice through the cart.
A cart only seems to last about three ciggs worth for me, (about three to five drops of liquid) and then it begins to burn the filler material and begins to taste like burning vegetables.
It takes some work to learn the device but it vapes very nicely if the atty is up to par. I have a DuraC and use each one about the same amount. They have a different taste and draw even with the same liquid and each produce an equal amount of smoke. My N-Pro actually has a cleaner taste and much easier draw then the duraC, if only the batteries lasted as long. I have purchased three more batteries and two more attys and none seem to work as well as the N-Pro parts but the batteries are at least usable.
I like em both about the same and carry them both to work.
Gurgling sound is to much liquid in the atty(A little is Ok but not to much). Remove and blow through the threaded end hold paper towel up close to the end. Repeat until it is clear, also you can leave overnight on paper towel big hole down to drain.
Cleaning, it self cleans every so often and has a burnt sulfur taste but six or eight puffs usually clears it up after primer is gone. you can remove the cart and blow through the LED end for 4-6 seconds, you will see a little smoke come out the end. Do not over do this, to long and it will burn the atty up. After a while the smoke will decrease until it is very noticeable if the burn clean approach does not satisfy you soak in Coke or Dr Pepper for two hours, rinse throughly with water blowing a few mouthfuls through both ends. Blow dry through little hole until no more wet sound. Attach to a paper clip and use a blow dryer for several minutes. Use a damp paper towel to remove from clip and cool down. It will need at least two drops of primer now and a full cart.
juice gets through into mouth. remove the cart with paper clip wipe the cart off. Using damp paper towel twist inside of cart until it reaches the bottom and throw away the little round fiber inside the tube. Reassemble and draw slowly. There are two different type atty that N-Joy sends out, new ones in plastic and others. Some have bigger holes on the threaded side and allow a much easier draw some are small hole that a paper clip will not even go through. The smaller need a very light pull or it will suck juice through the cart.
A cart only seems to last about three ciggs worth for me, (about three to five drops of liquid) and then it begins to burn the filler material and begins to taste like burning vegetables.
It takes some work to learn the device but it vapes very nicely if the atty is up to par. I have a DuraC and use each one about the same amount. They have a different taste and draw even with the same liquid and each produce an equal amount of smoke. My N-Pro actually has a cleaner taste and much easier draw then the duraC, if only the batteries lasted as long. I have purchased three more batteries and two more attys and none seem to work as well as the N-Pro parts but the batteries are at least usable.
I like em both about the same and carry them both to work.
Last edited:
