No atomizer found

[CloudyWithChanceOfVape]

On your mod, look down into the hole where you attach your tank. Is there a small pin down in there with a slot for a screwdriver? (Im unfamiliar with the eleaf products).

If so, turn THAT counterclockwise 1/4-1/2 turn. For some reason you're just not making a contact.

 

[Two_Bears]

Where are these screws located on the atty? Thank you

If you are using an RTA (Rebuuldable Tank Atomizer) such as a Kayfun, Goblin Mini, Aqua, and many more, or RBA (ReBuildable Atomizer) like the Vector, Rogue, Veritas, Freakshow, Magma, etc there are screws that holds the coil to the base of the Atomizer.

If you are using the OCC HEADS OF A SUB TANK MINI there are no screws. The negative end of the coil is trapped between the head and the grommet, and the positive end is trapped between the positive pin and grommet.

In the RBA for the Aspire Triton the ends of the coil are trapped by two tiny screws on the head that screws into the base like a normal coil head.

If you are using premade coils or sounds like a damaged head.

 

[Two_Bears]

Inside the cap, where you attach your resistance wire COIL. That is ONLY for RDA's.

RBAs, RTAs, and RDTAs.

 

[CloudyWithChanceOfVape]

Thanks, that actually should have JUST said RBA. Because in my opinion, RBA stands for RTA AND RDA atomizers, since RBA stands for REBUILDABLE ATOMIZER. Thanks!

 

[sig-cmt]

Not all that familiar with the iStick TC40w, but perhaps the resistance of your atty is outside the working range of your mod...

 

[Two_Bears]

Thanks, that actually should have JUST said RBA. Because in my opinion, RBA stands for RTA AND RDA atomizers, since RBA stands for REBUILDABLE ATOMIZER. Thanks!

ReBuildable Atomizers covers the whole range.

But I wanted the newbies to not freak out wondering if that included Rebuildable Tank Atomizer and Rebuildable Dripping Tank Atomizers. Providing a more complete picture helps instead of hinders.

 

[CloudyWithChanceOfVape]

Yeah, that's why I was saying thank you. I actually wasn;t being a stiffler. I was actually being sincere lol.

 

[Two_Bears]

Not all that familiar with the iStick TC40w, but perhaps the resistance of your atty is outside the working range of your mod...

I have the same mod. If the build was too low it would give another error message instead of Atomizer not found.

My builds are around .8 ohms so I have never seen that error message but I think it says ohms too low or something like that.

I think the istick40tc can fire safety all the way down to .2 or .3 ohms.

 

[Two_Bears]

Yeah, that's why I was saying thank you. I actually wasn;t being a stiffler. I was actually being sincere lol.

No worries it's all good.

 

[sig-cmt]

I have the same mod. If the build was too low it would give another error message instead of Atomizer not found.

Very good. Learned something new about the iStick TC40w today