No Atty found msg?

[bingo6104]

So this is my first full day using my eVic. This evening the display has said no Atty found? Any reason why. I have had to cut it off then back on. Then it detects it. Its a new atty that came with my pt2 yesterday .

Sent from my Motorola Galaxy s3 using Tapatalk 2

 

[bingo6104]

So I took it apart tighten everything put it back on it detected the Atty so far. But now when I press the button it says max time every time I press it

Sent from my Motorola Galaxy s3 using Tapatalk 2

 

[MsComptrtchr]

What is "max"? Max puff seconds? Max temperature? Max ohms? Have you hooked it up to a computer to configure it? Sometimes the default settings are off - like the temp warning. I always have to turn it up.

Edit: ok, "max time" - sounds like you have the puff counter or timer on - go into the settings and change the timer settings.

 

[bingo6104]

What is "max"? Max puff seconds? Max temperature? Max ohms? Have you hooked it up to a computer to configure it? Sometimes the default settings are off - like the temp warning. I always have to turn it up.

Edit: ok, "max time" - sounds like you have the puff counter or timer on - go into the settings and change the timer settings.

Yeah that was it. What is that for ?



Sent from my Motorola Galaxy s3 using Tapatalk 2

 

[wbart]

It is so that you can control how many puffs you take, so you do not go overboard

 

[bingo6104]

Thanks... sorry for asking but I don't see the setting. All I saw as puff count and reset. I'll keep looking .I must be over looking it

Sent from my Motorola Galaxy s3 using Tapatalk 2

 

[rasmith1959]

So this is my first full day using my eVic. This evening the display has said no Atty found? Any reason why. I have had to cut it off then back on. Then it detects it. Its a new atty that came with my pt2 yesterday .

Sometimes you'll have to pull the center pin down slightly on an atomizer head to make good contact. When I first got my eVic I didn't have this problem, but then after I had started using a new batch of atty heads I did. Apparently there are some slight cifferences in the constriction of the atomizer bodies that cause this.

So I took it apart tighten everything put it back on it detected the Atty so far. But now when I press the button it says max time every time I press it

When attaching your clearomizer you don't want to really tighten it tight, just tight enough to make contact and that's it. Tightening it too tight can cause thread problems, ans push that center pin up causing contact problems.


Sent from my Sony Tablet S using Tapatalk 4

 

[bingo6104]

Where is the center pin at ?

Sent from my Motorola Galaxy s3 using Tapatalk 2

 

[rasmith1959]

Where is the center pin at ?

Sent from my Motorola Galaxy s3 using Tapatalk 2

Take a look at this picture:

The center pin for the atomizer head is at the bottom. Its the part below the white silicone insulator. When you're looking at the bottom of your assembled clearomizer, it looks like it has a slot for a flat blade screw driver. Though actually it is not threaded, the slot is for air flow.

Sent from my Galaxy Nexus using Tapatalk 4