No Tank - BF Genesis RBA

[Cevan]

If you guys haven't tried these yet... They are excellent, Flavor is off the charts.

NoTank by NoName

 

[FACE MEAT]

They've been discussed somewhere in REOville.

Have you used one atop a REO?

 

[Raynman]

Is there a US seller yet.

 

[Cevan]

They've been discussed somewhere in REOville.

Have you used one atop a REO?

I have ...they work well, I got mine through some trades but I believe they are still mainly sold out of Italian retailers.

 

[Filthy-Beast]

Looks great!, are they BF or did you mod it?

 

[Papa_Lazarou]

... and could you show us a shot with the cap off to see the build platform? Pretty please.

 

[Raynman]

They are made BF your wick should go around the positive post. juice hole is high and it flows down the post wetting the wick on the way down there doesn't seem to be any drainage. I've been thinking if I ever get one to try RXW around the post. Maybe Sleeve it over the post if it will fit.

ETA the negative post is low on the deck. Positive post like normal except wire goes under the post screw. Ya slipped in there Papa.

My bad it does have a wire hole this should present more info. http://www.esigarettanews.com/notank-by-noname-mods-gallery-details/

 

[Filthy-Beast]

Very interesting, that is a tiny air chamber. I'd be tempted to drill a lower drain hole.

 

[Cevan]

... and could you show us a shot with the cap off to see the build platform? Pretty please.

Here is my build for a regulated device comes out to about 1.5 ohms w 30g wire, on the Reo I use 3/4 or 4/5 of 28g wire... stuff a little cotton in the well and it wicks right back up the mesh. Usually get about 3-4 nice puffs before you need a squonk.

 

[Cevan]

I just wrap the wire around the positive screw and snug it, makes it much easier... just like any genny, you will have to fiddle with hot spots for a little while.