Non noobs please.
- Thread starter lillistar
- Start date
- th_trl_thread_readers 0
- Status
Need to know what carto you're using, or maybe it's a carto tank. If you're not sure, a link to it or a pic would be good. Typically, airflow is a atomizer thing, but not always.
For some reason I cant post a pic! I was going to but when I try it tells me im not allowed to post links.
My cardo is a standard 510, with just a generic pyrex tank. When I take it off my ace and put it on my lava tube it works fine tho.... there-in-lies my problem
I'm not a carto user but it sounds like your carto draws air through the 510 connection and the design of the ace won't allow that.
Thats what im thinking, so what cardo should I use, the 510 is the only one ive ever used.
Look at where the air holes are, usually toward the bottom of the tank somwhere. Those airholes can be plugged by certain mods.
For example, any tank with an air hole on the bottom of the base or stem is not going to get air when I put it on my Gnome mod--but it will get air if I put it on my stingray mod which has holes in the topcap to allow air in.
For example, any tank with an air hole on the bottom of the base or stem is not going to get air when I put it on my Gnome mod--but it will get air if I put it on my stingray mod which has holes in the topcap to allow air in.
yeah, exactly... A lot of clearomizers do the same, and some mods just aren't set up for that, you either get no airflow or very very restricted airflow... I can't think of any off the top of my head, but I know I've run into it before with some of the clearos my wife uses.
You could solve the problem with an airflow controller. It sits between your mod and your cartotank. They are pretty cheap and can be used for any setup that requires bottom air flow.
This is a SMOK one:
This is a SMOK one:
Ive found an iclear tank that works with my ace mod. Im getting it tomorrow. Thanks for all the help verry appreciated
- Status
Similar threads
