Noob needs help filling tanks

[Mike_S]

Thanks everyone for the help! I'm going to watch the videos, then give it another shot and report back.

Here's a couple more photos.

This is bottom end, which I believe is supposed to slide into the atomizer. It's sealed off from the looks of it.

This is the assembled e-cig. There's a tiny bit of liquid in the tank and I've gotten a few hits off it. Then it became empty.

 

[klynnn]

Yes it about the same as a 901 the diff is those little flaps. When you push it onto the atty sometimes you will get a burnt taste from that little piece of plastic that is punctured. We used to puncture the hole and clear away any shred of the plastic film then push it onto the atty.

 

[klynnn]

It only hold about half a mil so you can only put a few drops in

 

[Buggs5347]

Filling it from the mouthpiece end is going to do that because that is where the "smoke" vapor comes back through from the atomizer to the mouth. The juice chamber is actually inside/inbetween the vapor channels.

 

[klynnn]

When you get a chance look at the mini nova. After awhile on that thing you will love it.

 

[Mike_S]

Ah, success!

That's why I was having so much trouble. I was trying to fill it from the mouth piece end. Once the hole is made in the atomizer end, it fills up nicely. It creates a fairly large hole, which the bottle tip fits into perfectly. No drips this time!

Thank you all so much for taking the time to help this noob.

 

[Buggs5347]

Yay!!! That's what we are all here for. We've all been through these learning curves. Enjoy your vape!!

 

[Mike_S]

Thanks!