Not getting power to atty on dentonator

[whatagem]

Connector has power to it up until the atomizer is screwed on. After atty is screwed on, light stops wroking & no power goes to the connector. Have the thing ground directly to the case of the flashlight. Everything works unitl the atty is screwed on.

Please help--spent all weekend on it & this is where i am

Have rebuilt this thing 4 times with same results...don't understand what is going on. Have watched YouTube videos on builing dentonators, 12 or 14 of them. Did exact same thing but when I screw on the atty--no power to it & the led light dies.

 

[j0ker]

Sounds like the atty may be shorting out. Have you got another atty or a stock battery you can check the atty? A multimeter would be a good idea too.

 

[peaceoffcake]

Connector has power to it up until the atomizer is screwed on. After atty is screwed on, light stops wroking & no power goes to the connector. Have the thing ground directly to the case of the flashlight. Everything works unitl the atty is screwed on.

Please help--spent all weekend on it & this is where i am

Have rebuilt this thing 4 times with same results...don't understand what is going on. Have watched YouTube videos on builing dentonators, 12 or 14 of them. Did exact same thing but when I screw on the atty--no power to it & the led light dies.

I have same problem with Chuck and two RCR123a. The problem was one of the battery. Try another battery.

 

[Cisco]

Connector has power to it up until the atomizer is screwed on. After atty is screwed on, light stops wroking & no power goes to the connector. Have the thing ground directly to the case of the flashlight. Everything works unitl the atty is screwed on.

Please help--spent all weekend on it & this is where i am

Have rebuilt this thing 4 times with same results...don't understand what is going on. Have watched YouTube videos on builing dentonators, 12 or 14 of them. Did exact same thing but when I screw on the atty--no power to it & the led light dies.

Check your atomizer connector, you could have an insulator that has a tear in it. When you screw the atomizer on the connector it could be shorting out. a meter would be the best way to check this.


Cisco...

 

[YuckFou]

im havin the same problem with my madog-magmod.. i have a feeling cisco might be right cuz i had problems soldering wires to the atty connecter and probably got it too hot after trying to get the solder to bond 50 times or so.. guess imma have to order sum atty connectors or wait 4 a dead batt..