Nuck Fistpack with digital voltage changing

[Minus1724]

Yea I've read that, but breaktru used 1 button for up and down, I want to use 2 separate buttons. I know it can be done, I'm just not quite sure how. I'm still learning how to read circuit diagrams and spec sheets so both are still a bit confusing for me, it kinda feels like I'm trying to read Egyptian hieroglyphics.

HAHAHAA I know the feeling .. look here on page 3 http://datasheets.maxim-ic.com/en/ds/DS1869.pdf

 

[Minus1724]

while you were inside the fistpack, did it appear there might be room to bury the atty/bat connector inside (if the PCB were tilted or removed?), so that the tip would stick out where the switch is?

i really want to see this charger looking more like a Boge Revolution or Janty Stick, hee hee

no there is NO room for that the connector is only 1,5mm. trough the crome casing . And the battery ( 2600mah Aw ) is squished in there

 

[Silent Soldier]

HAHAHAA I know the feeling .. look here on page 3 http://datasheets.maxim-ic.com/en/ds/DS1869.pdf

I can barely understand those in even a limited fashion, but I at least see somewhat how the controll buttons are wired in, somehow I didn't notice that there is a separate pin for each. So other than the digital pot did you just use the v2 instructions?

 

[Minus1724]

I can barely understand those in even a limited fashion, but I at least see somewhat how the controll buttons are wired in, somehow I didn't notice that there is a separate pin for each. So other than the digital pot did you just use the v2 instructions?

had the same problem understanding diagrams 1 year ago

you need a 10k resistor in series with chips RW leg .. and just follow the V2 instructions

 

[outofjuice]

ooooo... its nice to see the pack is back

 

[Minus1724]

and now with toutch

 

[VWFringe]

no there is NO room for that the connector is only 1,5mm. trough the crome casing . And the battery ( 2600mah Aw ) is squished in there

think you misunderstood, i'm thinking where the pc board lays there might be room for the atomizer...?

 

[Minus1724]

think you misunderstood, i'm thinking where the pc board lays there might be room for the atomizer...?

yes there is room.. but you have to move the button on the side