**official canvape.com thread**

Status
Not open for further replies.

Northernshrink

Ultra Member
ECF Veteran
Verified Member
Jan 21, 2012
1,397
3,376
53
Bracebridge Ont Canada
A lavatube or Mini Kit is $59.95 now. Time for a big boy mod, pantera :)
Why would I want to pay you 59.95 For a Lavatube when I can order one for 109.95 from someone else :facepalm: UNFRICKINBELEIVABLE......

Can we also get
-4 or 6 bay charger (Pila B nice)
-Smoktech drip tips (colors look nicer than drippy)
-Voltage resistance indicator 510
 
Last edited:

X P3 Flight Engineer

Ultra Member
ECF Veteran
Verified Member
Feb 27, 2012
2,598
1,305
Moncton, N.B. Canada
MVVM: (snip) My gf likes them, they look good on the ego's, and they seem pretty leak-proof as long as that mouthpiece stays all the way down. Only had it leak once since I thought the mouthpiece was tighter against the seal but i had about a 1mm gap from gravity and my suction. I was laying on my back in bed and had it tipped all the way up in the air. (snip)

The SD tip is threaded and tightens with one and a half turns. A very nice feature! If you slack it a half turn it will allow the liquid to run down the tip, especially "on my back in bed". Really. LOL

And, yes, they look very good on the eGos!
 

X P3 Flight Engineer

Ultra Member
ECF Veteran
Verified Member
Feb 27, 2012
2,598
1,305
Moncton, N.B. Canada
snip <My SD had a little hissy fit on the second day, not much vapor, not a lot of flavour. I carried on and it was back better than ever about a half tank after the fit. I guess this is part of the breaking in, or just one of those things that life throws at us. My SD is 3.8 ohms (when warm, higher when cool) and my 1100 eGo passthrough gives me 3.9 volts. snip>

So that would be standard resistance and I understand that they have a very robust coil so they can handle all voltages and, hopefully, "works good ... lasts a long time".

It has a very short wick, so make sure it gets soaked often, especially when it is less than a quarter full the wicks will not touch the liquid when it is laid (layed?) flat. I often leave it inverted so that it is constantly soaked. ( It has a screw top. Does Not Leak, except in the special circumstance of the post above ).
 

shiver905

Full Member
Feb 8, 2012
47
47
38
Hamilton
I'm a new member here its just been about a month since my last real smoke.
Shout outs to canvape for the AMAZING costumer support.

I'm currently using a k808 with the 901 (1100mah)

I'm thinking about grabbing a lava-tube. What differences are there from my current set-up?.
I under stand its VV but what will VV do for me?
 
Last edited:

northofamerica

Super Member
ECF Veteran
Verified Member
Feb 5, 2012
452
207
Saskatoon
The SD tip is threaded and tightens with one and a half turns. A very nice feature! If you slack it a half turn it will allow the liquid to run down the tip, especially "on my back in bed". Really. LOL

And, yes, they look very good on the eGos!

Last night I watched a few videos and I realized that it screws down! Now its even better! no leaks anymore. I did taste something coming from the mouth piece today but I think it was a little bit of trapped banana flavoured water vapor since it didn't burn my mouth from the nic. Time to order more for sure now that I know they are totally awesome AND you can take them apart fully! Now all we need is larger sizes and see how they perform the larger they get.
I'd say best top coil design yet from all that I have tried.

Still need a stone 2 tank to try so Ill get at least one of those. Anyone try the stone 2 yet?

I hope that it is better than the vision grande. I'm not a huge fan of the one I got from a friend since there is just too much wick in the ceramic cup. It traps lots of fluid so you shouldn't get a dry hit but it gives me a flooding suck every time. This also leads to juice running down the tube into the juice well on yer battery. Been playing with it on the LT and i get more dry hits than non dry hits. Tried lifting the cup seal, pushing it down further... Just cant get a good pull off of it.
I have only tried the one so it could just be an issue with the one grande having too much wick in there stopping proper airflow or something. I dunno. Anyone a huge grande fan that got them last week?
 

mopar

Unregistered Supplier
ECF Veteran
May 15, 2011
2,116
1,758
47
Toronto
www.canvape.com
I think Mopar used to sell audio equipment......


ROFLMAO! Thanks for that haven't found a lot of reason to smile this week.

Hey Mopar, can you bring in some flanged smoktech 1.7's? They're a great match for the tanks.

I'll see if I can grab some I don't know if they make them?

Why would I want to pay you 59.95 For a Lavatube when I can order one for 109.95 from someone else :facepalm: UNFRICKINBELEIVABLE......

Can we also get
-4 or 6 bay charger (Pila B nice)
-Smoktech drip tips (colors look nicer than drippy)
-Voltage resistance indicator 510

Most of our tips are SMOK but I decided not to grab anymore for a while because everyone is just using the to cross the $50 mark. So after all the mustard yellow ones are gone will do a heavy restock :)

The SD tip is threaded and tightens with one and a half turns. A very nice feature! If you slack it a half turn it will allow the liquid to run down the tip, especially "on my back in bed". Really. LOL

And, yes, they look very good on the eGos!

This is the only thing I have found I can vape upside down with and not get a mouth full of juice!

hey there anyone out there that already got there stardust from canvape know if they are lr or sr? and what ohm reading they are? thanx in andance for the info

They are supposed to be 2.7 +/- .2 but I haven't checked them reports they may be 2.9 all good unless your running a bat at 3.2 then you suck anyway muhahaha

No liquids at Canvape. Hardware only for now.

We are really trying to get some sort of DIY or e-liquid but we don't ever want to deal with nicotine because of Health Canada's stance on the issue so time will tell.
 

FunkyVapes

Ultra Member
ECF Veteran
Verified Member
Jun 12, 2011
1,881
1,042
36
Niagara Falls, Canada
So I put an order through yesterday morning (#1025) and chose Western Union to pay for it. It told me I would get an invoice soon, which I didn't.

I sent a ticket in but got no response. Just curious as to what is going on. If you guys are just busy, no big deal, I just want to make sure everything is on track.


Vape Groovily everyone :D
 

ThunderHammer

Full Member
Verified Member
Jan 5, 2012
57
33
Carberry, MB Canada
Just got my pkg from Mopar. Two hours with the SD and really like it so far. Although it is CE2 based, I like it much more than the Fluxomizers. Easy fill, no leak, Just keep an eye on the wick before taking a hit when juice is low. i'm thinking that this is the first iteration of the "perfect" carto!! I just can't see any drawback, except for making sure the wick is wet. Vaping 18mg Cherry Coke.... yummmmm!

Another thing, i was happy to see that the black juice level markings on it are, in reality, very fine lines; not at all like the picture on the website.
 

X P3 Flight Engineer

Ultra Member
ECF Veteran
Verified Member
Feb 27, 2012
2,598
1,305
Moncton, N.B. Canada
Just got my pkg from Mopar. Two hours with the SD and really like it so far. Although it is CE2 based, I like it much more than the Fluxomizers. Easy fill, no leak, Just keep an eye on the wick before taking a hit when juice is low. i'm thinking that this is the first iteration of the "perfect" carto!! I just can't see any drawback, except for making sure the wick is wet. Vaping 18mg Cherry Coke.... yummmmm!

Another thing, i was happy to see that the black juice level markings on it are, in reality, very fine lines; not at all like the picture on the website.

The top black line (apparently) is the recommended fill line. They need some air space. And yes, they are threaded. I like that!

This place should be like Christmas morning, with everyone getting their SD's today!

Keep your wick wet!!
 

mopar

Unregistered Supplier
ECF Veteran
May 15, 2011
2,116
1,758
47
Toronto
www.canvape.com
So I put an order through yesterday morning (#1025) and chose Western Union to pay for it. It told me I would get an invoice soon, which I didn't.

I sent a ticket in but got no response. Just curious as to what is going on. If you guys are just busy, no big deal, I just want to make sure everything is on track.


Vape Groovily everyone :D

I though western union was something you used to bail people out of jail with :) Don't worry Tom's on the case.

We had so much to do today we are just getting tracking info out now and going over our tracks to see if we missed anyone/thing. We can no longer accept paypal with anything regarding e-cig because it effects our other enterprise that we can accept paypal for. So everything as far as payment options go, will smooth out over the next couple days. Things were on track until the paypal thing. Today everyone that got their money to us(before 9am) had there goods shipped out. Other then cleaning up some of the outstanding payments for people that can't us EMT hyperWALLET or moneybookers 100% on the ball and full steam ahead.

Oh and we haven't been able to return or answer a phone call for a week. So just e-mail us for Pete's sake.

Oversized mail the $2.00 shipping option for people is taking forever. Like weeks so hang in their everything has been sent but taking an incredible amount of time to reach it's destinations.
 

pantera

Senior Member
ECF Veteran
Nov 18, 2011
162
70
Canada
Hey Mopar, if you guys are looking into diy stuff in the future, could you get some flavors from flavor art or apprentice? Also for the love of god please get plain menthol flavoring! I love making menthol fruits... I know it sounds gross but menthol apple is awesome!

Also, any chance of LR stardusts in the near future? I resent the 3.2v comment lol

Thanks
 
Status
Not open for further replies.

Users who are viewing this thread