ok.....510 atty just quit working

Status
Not open for further replies.

crashtestjeep

Vaping Master
ECF Veteran
Aug 14, 2009
3,935
100
Wilmington, NC
www.myspace.com
should look like this
the one one the right is before, left is after(notice center post is slighty above outer rim) and how urs should look sorry abt bad pic quality
IMG00545.jpg
 
Last edited:

crashtestjeep

Vaping Master
ECF Veteran
Aug 14, 2009
3,935
100
Wilmington, NC
www.myspace.com
It depends on what batt I use but due to a loose center post on some attys, I sometimes have to readjust every now and then, esp when I use said atty on some other batt then switch back to one that needed atty adjustment to begin woth...hope this works..if it doesnt its prob dead but only way to tell for sure is to use a meter.
 

crashtestjeep

Vaping Master
ECF Veteran
Aug 14, 2009
3,935
100
Wilmington, NC
www.myspace.com
ohh......i see...
theres like a rubber gasket under there
yeah, sometimes it gets heated/juice leaks and loosens that center post a bit. That gasket keeps the post from touching outer rim, center post is pos and oputer rim is neg. if the gasket wasnt there it would cause a short if they touched together.
 

crashtestjeep

Vaping Master
ECF Veteran
Aug 14, 2009
3,935
100
Wilmington, NC
www.myspace.com
Prob dead, may want to try cleaning it to be sure, run some hot water thru it, let it soak for a few, blow it out (both ends) and try again in the morning...hope it works.cleaninng helos if stuck on juice clogs it making the clog too thick for juice to vaporize thru...that may be the prob so try that and if still dead i morning, its a gonner :(
 
Status
Not open for further replies.

Users who are viewing this thread