OK, new head on Evod but now no draw

[ZNinja]

Draw off battery is wide open and not even going through the 3 airholes...on battery you are depending on the airholes. My Evods sometimes act stupid like that too, haven't figured it out either...

 

[sychodelix]

It's also possible the way the head is put together, the lower coil and wick is packed too tightly and not letting any air get past it. Check your firing pin position as well.

Past that, I'm as stumped as you. Could just be a faulty head.

 

[crxess]

Evod is going to far down on the device and restricting air to the Center.
The outer holes are being blocked by the 510 connection.
Look in the Vamo forums for the Vamo fix.(collapsing center pin and damaged grommet)

Always only snug to contact and stop.

Kgo battery, lift center pin with a paperclip or tiny screwdriver.

 

[jcco]

I threw in the towel after having the thing completely flood on me. Nice mouthful of juice.

I tossed the brand new head away. I put on another and am happy to report it hits like a champ. Hard to say what in the world was wrong with the bad one.

Thanks for all your replies & ideas. The new one screwed down just like the other one & it's still a mystery what was wrong. QC is all I can guess.

Faulty head.

 

[crxess]

Now go dig it out and Dissect it to see what was wrong. Otherwise you will just keep throwing money away and never gain anything.

Also good to have if you ever decide to try rewicking.

 

[Unforeseen]

Moved to Assorted PV Topics - Clearomizers