Old Liquid - Liquid after the discovery of RBAs

[John_]

Now that I've jumped into RBAs, specifically RDAs, I've found that a lot of the juice I already have is un-vapeable. There is nothing wrong with the juice other than the fact that it hits me like a brick wall when I take a drag because of all the nicotine (11-18mg juices). With the coils/RDAs I've been using everything hurts unless I go to 6mg or below.

What did you do with your juice? Did you already have lower juice so it wasn't a problem?
I might buy more of the juices at 0mg and mix them down but I don't know I think I'd rather just buy new juices.

Equipment:
VAMO V3 w/ IGO-L
Silver Bullet w/ Kick2 and Phoenix V5
Titan w/ Helios

I can't use the IGO-L right now, I need to drill out the air hole it's too tight of a draw for me after using the Phoenix/Helios and I haven't gotten around to it yet.

 

[Dlovell]

Yea just buy new juice and give the old stuff away.


Sent from my iPhone using Tapatalk - now Free

 

[Spacedoutart]

I buy lower nicotine juice to mix in to make a lower nic juice. Or save it for when you really need that nic. hahhaa

 

[John_]

Yeah... I tried an 18mg juice that had some menthol... It felt like I was breathing in sandpaper...

I buy lower nicotine juice to mix in to make a lower nic juice. Or save it for when you really need that nic. hahhaa

 

[savagemann]

Since I started using rbas and rdas I have dropped down to about 6-8mg. Before was at 10-12mg, with a few random 14-18mg juices.
I keep the higher nic juices to use in my old clearos for out an about.
I have found that if I decide to bring an rda to work, I can get away with 1 or 2 quick pulls on 10-12mg to get my nic fix on.
I spend less time vaping and more time working that way, which Im sure makes my boss man happy.

 

[Pstarsr]

Couldn't you buy some pg ( or vg ) unflavored and thin it out. Lower the nic level of juice you already have now, until you order some lower levels. Might .... with the flavor concentrations though.

Course I don't know the calculation to do, but say its 18mg or 1.8% by volume of a 10ml. Add 5ml of pg would make it 9mg .9% by volume ? So say 2.5ml of pg make it 12mg roughly. These are all examples, not exact calculations. Just me spitballing.

 

[John_]

I can't vape that high with what I'm using, it has to be 6mg or lower. (6mg is the highest I can tolerate). I've been using a dual coil build in my Helios. I'm going to setup a normal single coil build in my drilled out IGO-L so that I can vape the liquid I have that I like. The rest I will give away.

Since I started using rbas and rdas I have dropped down to about 6-8mg. Before was at 10-12mg, with a few random 14-18mg juices.
I keep the higher nic juices to use in my old clearos for out an about.
I have found that if I decide to bring an rda to work, I can get away with 1 or 2 quick pulls on 10-12mg to get my nic fix on.
I spend less time vaping and more time working that way, which Im sure makes my boss man happy.

That would work if I wasn't worried about losing the flavor. To not dilute the flavor I'd have to buy a lower nic or even 0nic version of the same juice and mix the two. I just got 5 juices from Ahlusion all at 0nic and I am enjoying them very much.

Couldn't you buy some pg ( or vg ) unflavored and thin it out. Lower the nic level of juice you already have now, until you order some lower levels. Might .... with the flavor concentrations though.

Course I don't know the calculation to do, but say its 18mg or 1.8% by volume of a 10ml. Add 5ml of pg would make it 9mg .9% by volume ? So say 2.5ml of pg make it 12mg roughly. These are all examples, not exact calculations. Just me spitballing.