I am wondering if anyone has had this issue, I am thinking that the 510 connection on the omega is too short and not making contact on the firing pin on the nemesis. I have a omega clone from angelcigs, and a nemesis clone from a local shop. I have a patriot clone rda and it fires in the nemesis and works just fine. The omega works and fires on my mvp but not on my nemi. Has anyone else had this issue with an omega clone?
Also, on a side note, I got the magnets and extended contact pins from fatdaddyvapes and I cannot seem to get the extended top pin to work correctly in the nemesis. The top extended pin is much larger than the original and I have the nemesis in 18650 mode and configured correctly and with this pin the bottom switch sticks out way too much because of the larger pin. This is with 2 beauty rings. I have a purple efest 18650 30A battery flat top. And if I try with the kick ring there is way too much room even without any beauty rings. So I am wondering how to use this top extended pin, the fatdaddy website says you can tighten your nemi with the beauty/kick ring with the extended pin, but I am finding that it is too long. I have seen videos where they are installed and don't have that problem with the bottom switch being too far out.
Any help would be appreciated, thanks.
Also, on a side note, I got the magnets and extended contact pins from fatdaddyvapes and I cannot seem to get the extended top pin to work correctly in the nemesis. The top extended pin is much larger than the original and I have the nemesis in 18650 mode and configured correctly and with this pin the bottom switch sticks out way too much because of the larger pin. This is with 2 beauty rings. I have a purple efest 18650 30A battery flat top. And if I try with the kick ring there is way too much room even without any beauty rings. So I am wondering how to use this top extended pin, the fatdaddy website says you can tighten your nemi with the beauty/kick ring with the extended pin, but I am finding that it is too long. I have seen videos where they are installed and don't have that problem with the bottom switch being too far out.
Any help would be appreciated, thanks.
