Omega RDA fasttech clone

Status
Not open for further replies.

Thatfoochris

Full Member
May 3, 2014
11
0
Fontana, CA
I bought an Omega clone from fasttech and upon receiving my product I had noticed that the holes for the coil where drilled dead center. I didn't expect much from it considering I had only paid 7$ but I mean how hard is it to drill the holes in the right spot? Regardless, I was wondering if any of you ran into the same problem and have found a solution? Should I drill out the holes in the correct spot? Have any of you? I'd appreciate any information and any pictures that you guys could show me to enhance my vaping expirence on this cheap atty.
 

Thatfoochris

Full Member
May 3, 2014
11
0
Fontana, CA
image.jpg

image.jpg

This is my current build on the omega clone. Comes in at .4ohms
 
Status
Not open for further replies.

Users who are viewing this thread