One wall adapter to charge them all???

[Garemlin]

Had a quick charging question. I have a starter kit from V2 that I have been using for about a month. A few weeks ago I ordered a Volt 78mm but didn't get a USB charger. Thought it would work but was told by CS that it isn't a good idea to use the V2 USB charger. So now I have an X2 900 on the way. I plan to order another Volt 78mm for on the go and am going ahead and order a USB charger whileI am at it. Question is can I use the USB wall adapter I have now on my Volts and X2????

Here are the specs of the wall adapter....

Input 100-240v
50/60Hz 0.3A
Output 5V
1000mA

I also have another one for my phone that has these specs.....

Input 100-240v
50/60Hz 0.2A
Output 5.1V
850mA

Will either of these work fine??? If I can save a little $$$ and not have to get another wall adapter it would be nice.

And one more question. I have a dual USB car charger. Is there any issue with using this with any of my batteries???

Thanks

 

[Imagine]

Yep those are fine

 

[Garemlin]

Yep those are fine

For my 78's and X2 900??

Tap'd from my Maxx

 

[3mg Meniere]

I have four 808 chargers plugged into a USB hub, which is plugged into a wall adaptor which is plugged into a surge protector.

 

[cindycated]

I use a powered USB hub too. This one: Digital Innovations Hub
Power: 5V/2.5A AC Adapter
On/Off switch
I use the top ports for stick batts and the side ports for X2s.

You can use just about any USB wall adapter (not the dongles - those are device-specific), but the higher the amps, the faster it'll go. Plus a powered hub would let you charge them all at once.