Oring sizes for drip atty clones

[RobUpNya]

I was wondering if anyone out there has experience with the drip atty's for sale on fasttech.com. I'd like to know the sizes of the orings in the following atty's if you guys know it:

IGO-L
IGO-W
AGI DUAL
TRIDENT (CLONE)

 

[State O' Flux]

Something I've been doing for a few decades now in the motorcycle biz, and it crosses over into the vaping biz... is that can make your "o-ring life" a bit easier by making your own o-rings.
If you know the typical diameters - 2.0, 2.5, 3.0mm etc etc that you need, you can buy 0-ring stock and o-ring adhesive and make your own.

 

[PuddleSnake]

I rebuild a lot of carbs so thanks for that link flux.

 

[State O' Flux]

I rebuild a lot of carbs so thanks for that link flux.

No sweat... just pick the right rubber for the application and you're good to go. I've got everything from Amal Concentrics to Magneti Marelli low pressure side FI out there with DIY o-rings. No comebacks... knock on wood. ;-)