So.
I tried making a 70/30 juice.
but I did it by weight. I aimed for 0.1kg total.
I did 0.025kg of flavor, 0.05kg of pg, and then the rest vg. I accidentally got it to 0.15kg, when adding the VG, so there should've been theoretically a little more than 30% pg.
However, when I put it into the new Smok TF-D tank, I just got, and vaped it at 60w, and then 63.5w, it wasn't logo until the coil burnt, but I was vaping below the 65w the coil was rated for.
So, I assume maybe by weight is not accurate enough, and it resulted in the juice being too thin?
Is it better do to percentage by ML then? or what?
EDIT: The flavor I used, Lorann Oils "Super Strength Cotton Candy" while it has pg, also has triacetin, so I am not sure whether that could have contributed to it being too thin as well, or not.
I tried making a 70/30 juice.
but I did it by weight. I aimed for 0.1kg total.
I did 0.025kg of flavor, 0.05kg of pg, and then the rest vg. I accidentally got it to 0.15kg, when adding the VG, so there should've been theoretically a little more than 30% pg.
However, when I put it into the new Smok TF-D tank, I just got, and vaped it at 60w, and then 63.5w, it wasn't logo until the coil burnt, but I was vaping below the 65w the coil was rated for.
So, I assume maybe by weight is not accurate enough, and it resulted in the juice being too thin?
Is it better do to percentage by ML then? or what?
EDIT: The flavor I used, Lorann Oils "Super Strength Cotton Candy" while it has pg, also has triacetin, so I am not sure whether that could have contributed to it being too thin as well, or not.
Last edited:
