I have a question. I normally make 30ml bottles of e liquid to enjoy. I usually just enter everything into ejuicemeup (pg, vg, nic, distilled water, flavor) and mix, steep, enjoy. I was wondering how do I mix up a base without the flavor, say 100ml + to just pull off x amount, add flavor for 30mls? My apologies if this has been answered before.
PG/VG/Nic Base
- Thread starter MikeTay9779
- Start date
- th_trl_thread_readers 0
- Status
I just mix up an 8mg base 250mls at a time. My flavor percentages vary a little but if I mix 20% flavor it is 6.4mg. Close enough for me. I mix max vg so I don't have that complication.
A 35/65 vg heavy mix at 7.5 or so should work. This will depend on how much flavoring your standard mixes have. You probably won't notice a difference as long as it's close. Depending on gear.
A 35/65 vg heavy mix at 7.5 or so should work. This will depend on how much flavoring your standard mixes have. You probably won't notice a difference as long as it's close. Depending on gear.
personally, and especially since you USE EjuiceMeUp like I do, I'd make the recipe using Ejuicemeup (then do "SAVE AS" so you have it recorded) - and add exactly all the ingredients EXCEPT the flavor.
Then you'll have a base that, when you DO add the mls of flavoring, is precisely what you wanted.
You could do a 30 ml recipe and quadruple each ingredient in the big bottle.
Or you could do a 120 ml recipe, and ad 1/4 the flavoring amount to each 30 ml bottle...
Then you'll have a base that, when you DO add the mls of flavoring, is precisely what you wanted.
You could do a 30 ml recipe and quadruple each ingredient in the big bottle.
Or you could do a 120 ml recipe, and ad 1/4 the flavoring amount to each 30 ml bottle...
You can also enter an approx percentage for flavor this will compensate the base for adding flavor. I use a 10% compensation.
- Status
