Phoenix problems

Status
Not open for further replies.

bace a flunt

Senior Member
ECF Veteran
Verified Member
Nov 1, 2012
222
80
US
I just got my first rba in the mail other day, a phoenix clone. I can't vape over 3.6v at 2.2 ohms without getting a burnt taste. The coil was wrapped evenly around the wick and there did not appear to be any hot spots. I just tried installing one of the pre made silica wick/coils today and I just can't get it right. I wasted all 5. What keeps happening is I get the wires in the post but I can't get the silica wick to stay at the bottom where the juice pools up. I can kinda cram the wick under the coil, but I don't think it goes into the little pit reservoir pit in the bottom. I tried pushing the wick down before I put the wire in the posts, I tried having the coil perpendiculat to the posts, I tried pushing the coil down towards the bottom, and I tried shortening the wick. A lot of the time the wick would unravel which makes it even more aggrivating. On the last one I just left it the best I could. The wick was pushed down under the coil, I couldn't tell if it was touching the reservoir at the bottom. Anyways I put 15 drops completely saturating the wick and got a burnt taste on the third drag. The coil was wrapped was wrapped pretty even.

So does anyone have suggestions? Is there anything I can do to make it withstand higher voltage (that is once I figure out how to put a new wick in)?

Also, what do you think about this setup? I supposed cotton would be much easier to work with than silica wick.

:mad:
 

bzmotoninja83

ECF Live Chat Moderator
ECF Veteran
Verified Member
Jul 2, 2012
2,161
2,796
42
Hopewell, Va
I had the same issue with a similar phoenix clone. Came with stubby wick setups. What I did, instead of dripping a few drops every drag is a ss mesh setup. It almost always wicks and haven't had a burnt taste yet. Right now I have one with a sorta U shape wick.

Sent from my HTC One X using Xparent Green Tapatalk 2
 

pdib

ECF Guru
ECF Veteran
Nov 23, 2012
17,151
127,511
www.e-cigarette-forum.com
I had the same issue with a similar phoenix clone. Came with stubby wick setups. What I did, instead of dripping a few drops every drag is a ss mesh setup. It almost always wicks and haven't had a burnt taste yet. Right now I have one with a sorta U shape wick.

Sent from my HTC One X using Xparent Green Tapatalk 2


Dude! ▲ check out your number of posts! ▲ :evil:
 
Status
Not open for further replies.

Users who are viewing this thread