Pin on innokin v3 crushed

[Synisity]

OOOk so i got another innoking v3(lost the other one :/) and that same day i put a dripper on it that i didn't realize had its positive post pin way far out so i guess when i screwed it on to my innokin it crushed the unsulator/spacer between the pin and the bottom. So now not only does it short super easy just i almost always have to fidgit with the pin to pull it out in order for any atomizer to make contact and fire. So i can temporarily fix it every time i switch atomizers but thats a huge pain in the neck. Does anyone have any ideas for a permanent fix? Thanks in advance you guys rock!

 

[Ding]

Are you talking about the brass base in the 510 connection on the innokin that makes contact with your cartos etc.? If it is just pull the base out,you can use a thin ,small screwdriver and pull it out carefully,you'll see some wires,keep pulling it out till you have enough to grasp,not wires but the brass head.Go to home depot or any place that has O rings and get ya few #60 O rings.Slip it over the brass center piece that makes contact with your cartos etc,it will slip over the head.Once you do that push everything back into place.You should be good to go from there.

took a while but this may help,if this is the problem you have.Hope I read it right