Please help with melting carts!!!

[Laguna6866]

Hi all! ive been vaping for about a year, and have a problem that i cannot solve no matter what i do Whenever i vape any device over 3.7v, and or use a LR (joye 510) attys. My cartridges melt at the part that is closest to the atty. This is very frustrating because it is my preferred way to vape! Yes i line up the carts correctly, and have tried the obvious ways to fix this...no luck! If any "expert" has a simple fix for this, please let me know! Thank you

I currently vape on a mako 3.7v and hello 016​

 

[Kate51]

Without knowing what your setup is, if carts are too close to the atty they can be trimmed shorter.
I use 801 attys and carts, and there seems to be no "standardized" fitting, and different manufacturers. So I have to trim some about an eigth of an inch, sometimes a little more. Very seldom do I run across one that is just right. Yes, they do get scorched, and if you don't trim them it sure spoils a good vape. If it's scorched too bad you have to start all over and try to clean the atty, and then use a new cart, trimmed of course.

 

[PaulCincy]

Ditto, have same problem,,,,but for some reason mostly with the Tappered tips ones..The standard carts don't seem to do that much....wonder why?....Good luck...have not found anything either,,,,will try the cutting thing that Kate suggested...Take care,
and Enjoy the Adventure...