Please help!!

[armbarvictim]

Hey I just got my evo vv pv and I bought 3 of these to go with it 3.5ml Dual Coil Tank Chrome/Black

this is the unit i boughtEVO V2 Kit

are these not compatible?? I will be ...... if not. I filled the tank properly and primed it properly, waited a couiple minutes and it pulls absolutely nothing.

the tank came with these tiny rubber rings too am I supposed to put those on somewhere?

Please help

 

[Stosh]

The bad news is the DCTanks usually run 1.5 ohms +or- a couple of tenths and your new PV is described under the Safety section as

Safety:
-Short circuit protection: If the resistance of atomizer is less than 1.5 ohm it will stop working. The white LED flashes 3 times to show the alarm.

 

[armbarvictim]

well I may have screwed it up after all I filled the tank I primed it wrong by filling liwuid right into the center of the carto. damn

 

[armbarvictim]

what would the proper carto be for this unit than?

 

[Stosh]

For a 3.7v rig of any type I prefer the CE2 cartos, (at about 2.5 ohms) but they do take a bit of adjusting and modding for best performance. Most people like the Boge 2 or 3 ohm cartos, at 3.7v.

I just received a shipment today with some Vision 3.5mL to try something new...(I'm a vapeoholic...) and they vape nice, not sure how they will hold up for long term use yet. Cartos are reasonably cheap, I will try ONE pack of just about anything, see if I like it, they are meant to be disposable. The one's that I don't like that much go into my stash in case of zombie attack.......(or a slow mailman)

p.s a nice very cheap option for using the DCT with enough amperage, and battery safety...
http://www.e-cigarette-forum.com/forum/battery-mods/106016-how-build-puck.html#post1596382
I use one as my primary PV everyday......and if you have questions you can post in that thread, lots of Pucksters around willing to help.