Pre-made wire

[Devonmoonshire]

I do a really good hot water rinse for about ten to twenty seconds and then just dry burn until it stops smoking on me and have been using the same coil I built last Saturday since. I have a few juices that gunk it up pretty good and this method cleans them spotless for me and yes taking the time to blow the ashen gunk off really helps, not just to remove the gunk but also to add a little cooling to the wick and wire between burns. Just remember to only burn until you see a glow then let it off, otherwise you will run a much greater risk of popping the coil and then you have to start all over again with a new one.

Hope this helps a bit;
Nate aka Darth Vapor

 

[Ezkill]

I like the toothbrush idea...off to walmart

Yea you just kind of have to clean it a bit of a different way since you can't dry burn but it works just as well.

 

[Natron]

I guess i won't try on this wick...while in walmart i left my GG/Ody in truck and didnt notice button was pushed...man that thing was hot.
Good thing I travel with a backup.

 

[Ezkill]

I guess i won't try on this wick...while in walmart i left my GG/Ody in truck and didnt notice button was pushed...man that thing was hot.
Good thing I travel with a backup.

Doh....lol. The button lock is your friend. That being said I did this too once. I put a stealth with Ody in my pocket without locking it. Got pretty hot, no harm done. Learned my lesson.