These instructions are enclosed with your Precise IMR switch:
Precise IMR 10440 Switch Installation:
Items needed: Ideal Noalox lubricant, Pen/Pencil, IMR Switch and included O-rings, IMR or AW 10440 battery, Precise 10440 Unit.
1. Remove top, bottom, switch and spring from your Precise.
2. Using a pencil or pen, insert the pen through the switch end of the Precise and push the pre-installed .070 thick O-ring out through the top of the Precise.
3. Place one of the included .100 thick O-rings with your IMR 10440 switch just inside the top of your Precise 10440 and utilize a battery to push the O-ring all the way down until it seats against the ledge towards the bottom of your Precise.
4. Next take the .070 thick O-ring you removed earlier and re-install it on top of the .100 thick O-ring you just installed using the same method to push it in.
5. Apply a dab of Noalox to the top of the switch where it contacts the battery. Also apply a dab of Noalox to the contact post where it contacts the top of the battery. Also, apply a dab to the atomizer contact post and atomizer threads and both the top and bottom cap threads.
6. Insert one IMR or AW 10440 battery and re-install top and the bottom shield, switch and spring. You will feel the O-rings compress down on the last ½ turn or so of your top cap.
7. If the battery still has up and down play, remove the .070 thick O-ring and replace with the extra included .100 thick O-ring.
Precise IMR 10440 Switch Installation:
Items needed: Ideal Noalox lubricant, Pen/Pencil, IMR Switch and included O-rings, IMR or AW 10440 battery, Precise 10440 Unit.
1. Remove top, bottom, switch and spring from your Precise.
2. Using a pencil or pen, insert the pen through the switch end of the Precise and push the pre-installed .070 thick O-ring out through the top of the Precise.
3. Place one of the included .100 thick O-rings with your IMR 10440 switch just inside the top of your Precise 10440 and utilize a battery to push the O-ring all the way down until it seats against the ledge towards the bottom of your Precise.
4. Next take the .070 thick O-ring you removed earlier and re-install it on top of the .100 thick O-ring you just installed using the same method to push it in.
5. Apply a dab of Noalox to the top of the switch where it contacts the battery. Also apply a dab of Noalox to the contact post where it contacts the top of the battery. Also, apply a dab to the atomizer contact post and atomizer threads and both the top and bottom cap threads.
6. Insert one IMR or AW 10440 battery and re-install top and the bottom shield, switch and spring. You will feel the O-rings compress down on the last ½ turn or so of your top cap.
7. If the battery still has up and down play, remove the .070 thick O-ring and replace with the extra included .100 thick O-ring.
