Priming a carto tank...

[cocacola31173]

Ok so this is my carto tank routine. I usually have a lot of flavors to rotate through and I only have 2 tanks...so far...and what I do is when I switch out the juice to another in my tank I take the carto and slip the plastic cover, which I cut the top off of...over the hole and then put the rubber mouthpiece on the top and put it on the juice bottle with a rubber band.

My question is when I come back to that cartomizer is it necessary to refill the carto again even if it wasn't dried out when I stored it or can I just take some primer puffs when I got it into the filled tank?

Also I have been using Smoktech cartos and just ordered some Boge f 16 ones to try out. Does anyone here have any experience with these and are they better then the Smoktech ones?

Thanks!

 

[Baditude]

If you tape the carto holes and cap both ends of the carto with those white/clear condom covers that new cartos come with, you should be good to go when you get back to using it again.

I always "top off" a carto each time I refill a tank, so I would do the same if I was putting that used carto into a fresh tank. Don't forget about the tooth pick trick or use a tank tool to keep juice out of the center air hole.