"Pro MT3 Tank" for my VAMO...0_o

[PondScum]

I loves my T3's, but when I got the VAMO I could no longer use them w/o an adapter. I got my Protank at the same time as the VAMO knowing this. I love it to but lets face we all break things from time to time. I saw someone on ECF who broke his Protank use an eGo sleeve and a drip tip to mod-ish a Protank Dripper. It got me to thinking. I did a little looking and figuring, realized the rubber piece from an old clearo would fit perfectly up to the inner tube inside the MT3 if I put it on the Protank coil head unit. I knew the base unit would screw on to the MT3 cause of the dripper mod-ish post I had seen earlier. What do you know, I put some juice in it and it worked without leaking. Hits like the Protank for the most part, but looks like the MT3 gee did I ever feel like the clever one.

​

 

[VapRLady]

This is so AWESOME! Cudos for making the best out of a bad situation!

As a note, I would like to mention that if you order the new MT3 atomizers, they have been modified to now fit the Vamo. Make sure when you order that you talk to them first and make sure they have the new atty's. They are still knurled but are much narrower to fit inside the Vamo juice cup.

 

[PondScum]

I did not know that they now fit...now I feel less clever.

 

[VapRLady]

I did not know that they now fit...now I feel less clever.

What you have done is genius, so many people, including myself, rebuild atty's so we still need some options, also, reusing a broken Protank into something useful is a GREAT IDEA! Very clever!

 

[Wizzlefits]

Bloody AWESOME!
I've done the rubber flip (where you flip over the top rubber seal on the T3 atty & it then pops over the center tube) to all my T3 & MT3's. I gave your trick a shot, minus the carto part (cause I don't have one) and so far it's not leaking.

And it works on my K100 & Telescope mechs!!

If you use a EVOD coil head in your MT3's it will tighten up the draw nicely. Works on the ProTank too. (not my idea, another ECF member)

Got the weekend off, so I'm going to Frankenstein some stuff! LOL!!

 

[Wizzlefits]

As a note, I would like to mention that if you order the new MT3 atomizers, they have been modified to now fit the Vamo. Make sure when you order that you talk to them first and make sure they have the new atty's. They are still knurled but are much narrower to fit inside the Vamo juice cup.

OOOHH NOW you tell us! LOL!
I just ordered a few MT3 & EVODS a couple weeks ago, along with a Vamo. They didn't fit.
But the do NOW!!!

HAH!!
I can run my 1 ohm protank coils in my MT3's!