Hi there. Looking for help here. Got my ProTank II last week, and it worked like a champ on my Vamo. Now all of a sudden today, they will not play nice together. Just a gurggling sound, no vapor, no taste. So I replaced the o-ring on my Vamo post again, and still no go. Put the ProTank on my Gripper, vapes like a champ. Ego VV Battery as well, very little vapor. Back to the Gripper, works like a charm. Replace the head, install just that on the Vamo no go again. Put ol'reliable T4 and Mini Nova on the Vamo, vapor galore! What gives here. No there is no fluid in the Protank, and no noises when in use on my Gripper. So does anyone have any ideas as to what is going on? The only thing I am thinking is that there was a little bit of leakage around the last o-ring that was on there and am worried that it may have gotten inside. I tried getting the top off with no luck either by following the online video so I may clean the inside of it. Thank you.
Vamo V2 Not Playing Nice With ProTank II
- Thread starter neos
- Start date
- th_trl_thread_readers 0
- Status
Protank II heads are notorious for leaking/gurgling
Take the coil chimney off (wiggle it off), remove old crappy flavor wicks, get a piece of cotton and roll tightly into a wick, lay across the coils using the regular silica wick (you don't have to put cotton in the coils but you can), put chimney back on and rubber grommet/stopper, trim excess off with toenail clippers
That should fix ya up
Take the coil chimney off (wiggle it off), remove old crappy flavor wicks, get a piece of cotton and roll tightly into a wick, lay across the coils using the regular silica wick (you don't have to put cotton in the coils but you can), put chimney back on and rubber grommet/stopper, trim excess off with toenail clippers
That should fix ya up
Last edited:
I'm going to try the cotton fix since I have loads of boiled cotton sitting around. If that doesn't help try running your finger nail in the very bottom gap under the gromet on your atty head. I do that with all of my PT2 heads before installing them.
I have 3 Vamo V3s. I use PT2s on all of them. On one of them the center post is higher than the others so it pushes the positive pin on the PT up and smashes the grommet a little bit. That tank won't work on anything else and sometimes I have to pull the pin back down to get it to work. I dunno if this helps your problem but I'm just letting you know.
- Status
