Probably a dumb question, but...

Status
Not open for further replies.

Cassie

Ultra Member
ECF Veteran
Verified Member
Dec 17, 2010
1,043
551
60
Missouri, United States
Usually just 2-3 drops on the atty, then vape a while ( I get 6-9 draws on it) then another 2 drops or so...

If you do flood it, unscrew the atty, just grab a tissue and blow into the open end with the tissue wadded by the threaded end to catch the juice and blow out excess, wipe atty, wipe battery at the connector area real well also then you should be good to go. Sometimes a lil swish and a few blow-throughs in some pure grain alcohol (vodka, everclear etc...) will clean it out also. That works for changing flavors too =)
 

leannebug

Vaping Master
ECF Veteran
Mar 5, 2010
4,694
561
the deep south
Flooding an atty is no big deal. You can blow it out and keep on going. It won't kill it. (we wash them and submerge in water, etc)
You can even 'flood' a batty and repair it. Though that is tougher to do. Takes a lot of hanging upside down to drip and sucking out the juice from the batty end (electric zap anyone?) and more drying and a little praying.
Doesn't always work. So if you use auto batts, I suggest keeping a good supply on hand!!


Sent from my pod
 

Aresi

Senior Member
ECF Veteran
Jan 24, 2011
267
16
Fremont, CA
Yeah, like the others said, if it gurgles it's flooded. You can either vape through it until it's vaping alright, or blow it out and try again. You know you need to drip again when you get that nasty burnt taste, and only 2-3 drops.

And remember: The only dumb question is the one you didn't ask. Don't be afraid to ask questions here. I asked a MILLION questions when I started, and everyone was so nice and helpful!
 
Status
Not open for further replies.

Users who are viewing this thread