Probably a silly question

[abbeyjewel]

I'm kinda new to vaping. I've only been doing it for 2 months now. I just bought an eGo Twist from Panda ecigs. I started with the regular eGo and I love it, but I really wanted to try the variable voltage. I was just wondering, what voltage should I start with? I have a lot of sweet flavors (Butterscotch, cheesecake, etc). I use the Kanger T3, and the Kanger T3S. I also just bought two topcoils (CE4 for both). All these are clearos. I'm not sure if I should start out with the 4.8 and go down, or the 3.2 and go up. Or if I should start in the middle?

Sorry if that's a really stupid question D:

 

[DoogieTony]

Not stupid at all.

Is suggest starting low and raising in increments till you find the sweet spot, you don't want to burn your wick on the first fire.

 

[State Of Zen]

Not a stupid question! I would start with 3.2 and go up, that way you don't risk burning/scorching anything. Hope this helps.

 

[abbeyjewel]

Thank you both very much! I'm really excited for it to come in the mail I'm also really excited to you the top coils. I'm still experimenting a lot. The top coils don't make much sense to me, but I figured I'd try them none the less. I ordered them.... technically yesterday. But I already can't wait for them to be here!

 

[williebb123]

just as a starting line a low ohm coil say 1.5 ohm i start at 3.7v ( for normal vaping ) 1.8 ohm 3.9v-4.0v i seldom go over 4.2v but i tend to use LR coils now extreeme vapors say .9 ohm-1.0 ohm they will do 4.0v and up hope this helps just remember that 1st ego batt that you got was 3.7v so i do not think you will have anything in your stash( tanks ,attys, etc) that will need to go below 3.7v

 

[abbeyjewel]

the CE4 with long wicks is 2-2.3 ohms. The CE4 with no wicks doesn't say, but I assume the same?
The Kanger T3 is 2.3-2.4 ohms. the Kanger T3S is 2.6 ohms.

Those are all higher than what you listed?

 

[williebb123]

thats all pretty high ohm you will more likely be 4.2v- 4.5v but could go a little higher

 

[abbeyjewel]

Thank you for the advice! I will definitely try that!

 

[Tvan]

You will be ok with using 3.7 v as your starting point. The coil I'm using right now is 2.7 ohms. I have it set to 4.1 v and can't see the screen.

 

[abbeyjewel]

THat's the kind of vapor I want!

 

[Tvan]

THat's the kind of vapor I want!

You will have fun with the twist. Don't be afraid to play around a little. That's the fun of it.

It's what tastes good to you. Some flavors taste better at higher voltages. Caramel flavors I set prob around 4.5-4.7v. Evryone is different and very possible you won't like it that warm. Burnt taste is universal. Just nudge it up to your liking.

 

[abbeyjewel]

So I got the twist.

It is amazing. I'm really enjoying testing it out!

Not sure I'm a fan of long wicks... I feel like the long wicks waste more ejuice... because they need more to be in it to not burn. I don't know...

 

[SirSteve]

Great choice on the Twist, ego's are still a mainstay for many of us with more advanced devices.

And your earlier question about voltage, like some have stated, start low and work your way up until you get your desired flavor and vapor. One trick that some use, add two to the ohms of the delivery system and adjust from there. A 2.4 ohm coil + 2 would = a 4.4 volt starting point. Its your vape though, do it your way.