Hey guys.. i been vaping for a while and not had this hapen before.. i am using a Hugo Vapor Rader and ot has been working with no problems until today... when i go to use it, when i try to fire, it says high atomizer the first time i push fire button followed by low battery (have tried multiple sets) when i press again. If i persevere and keep attempting to fire it works fine as if there were no problem until the next time i go to use the device when the process repeats.. i have taken the tank apart and cleaned and put back but the issue continues.. anyone have any ideas on what is wrong/what i should do?
- Status
How old is the device?
Have you cleaned out your 510 connector?
Have you checked the 510 connector on your tank?
Have you tried another tank on the device?
Possibilities: Devices 510 is worn out, tanks 510 is worn out, coil is bad, devices board has gotten wet from eliquid, wires in device have shorted or frayed, or fire button worn out.
Have you cleaned out your 510 connector?
Have you checked the 510 connector on your tank?
Have you tried another tank on the device?
Possibilities: Devices 510 is worn out, tanks 510 is worn out, coil is bad, devices board has gotten wet from eliquid, wires in device have shorted or frayed, or fire button worn out.
Last edited:
Other than cleaning out the 510 with a swab and high % alcohol, it might be time to retire the mod for a new one.
Last edited:
Appreciate the advice guys.. i suspected that the device was done but just wanted to make sure before i threw it out. I put the tank on a different mod and it works fine so i figure to just move on. Thanks though 
- Status
Similar threads
