Problem with flooded (I think) eGo clearomizer

[lefty23]

So I got a brand new CE4 clearomizer today and it was working great until I over-filled it. I had hoped if I kept hitting it eventually it would start to work again, but I've tried all day and can't get even a tiny hit. Does anyone have any reccomendations on what to do? Thanks in advance.

 

[Hulamoon]

Unscrew the battery from the clearo, and use a tissue or q-tip to wipe out any excess that is sitting in the battery well.

Second, take a tissue and place it over the bottom of the clearo then blow hard through the mouthpiece, till you stop hearing gurgling and nothing is going onto the tissue.

Those two things should clear the inner tube of the clearo and make your battery contact better.

 

[The Ocelot]

Those puppies can be fussy, as you noticed. I only fill mine up to the bottom of the silicone cup, just below the top of the wicks. If it's leaking from the bottom I roll up thin piece of paper towel and slide it up the air flow tube from the connection end, and, as Hulamoon said, wipe off the battery with a q-tip. If it's way too full you can syringe some of the liquid out or if you don't have a syringe, just pour a bit out - you can try to pour it back into the bottle, but if you miss, you've really only lost a small amount of juice.

 

[bacc.vap]

Sometimes, if it's not to bad and you have vv, you can just turn up the voltage for a couple hits and It'll clear it.

 

[lefty23]

Thanks for all the advice everyone; I tried all of your suggestions and they were definitely helpful, unfortunately more e-juice kept leaking into the air line. I ended up changing out the coil and now it works fine.

 

[John Alexander]

I had a particularly difficult-to-clean carto and I ended up using a pipe cleaner in both ends. Worked great after that.

 

[Ton Umali]

Remove it from the mod and try blowing holding the thread with a tissue. That usually helps me.

"Come to where the vapor is"