Problem with GLV3, advice please

Status
Not open for further replies.

burnsy

Super Member
ECF Veteran
Verified Member
Jul 22, 2010
485
64
46
Indiana
I ordered an unresisted glv3 to use at 7.4v. The thing is awesome and I love it. I have one major problem with it though, the orange tube that goes over the bottle nipple keeps popping off. I shoved it on there and twisted as hard as I could to the point that the orange part of the connector tube was almost touching the top of bottle cap, it worked for a while but it popped off without me knowing.

This resulted in me pushing on the bottle and dumping juice into the bottom of the mod severl times. I called Jay about this and he said he likely cut the orange tube too short and would send me another. He did this and actually send me two fill feeder tubes and two orange bottle connectors in a longer length.

I again pushed/twisted the crap out of it on to the bottle nipple until it would go no more but same problem :( The only solution I can think of is to super glue the orange part of the feeder tube on to the nipple of the bottle, I know this would fix it but, has anyone else had this problem and have a better solution?

Thanks!!!
 

bacc.vap

Vaping Master
ECF Veteran
Verified Member
May 18, 2011
4,147
2,219
Virtualville
I've had this happen a couple times on my mini, other than making sure the tube and bottle are clean ( no juice residue to make things slippery) I don't really have any helpful info. That being said, I'm working on an add on that will solve this problem and make juice feeding easier and more precise in general. I don't really have a lot of extra time right now but will post results once I have a working model.
 
Status
Not open for further replies.

Users who are viewing this thread