Problem with smok M80 and lemo 2

[jcglz26]

I have been using this mod with an Artic sub tank without any problems. I just got the lemo 2 because I wanted to start into the rta. The pre made cool that it came with it worked pretty good, I did my first coil and everything was ok, now in my second try I'm only getting different ohm reads every time I fire it. It's very annoying. What can I do?

Thanks

 

[EBates]

Not sure what an 'ohm lecture' is but I'd suspect either the coil is not secured properly (loose screws) or it is shorting to ground (coil touching the atty head).

 

[jcglz26]

Ohm reads, would be more accurate? I'm sorry for my English hehe

 

[EBates]

That's what I assumed a lecture to be. But you know what assuming gets you.
If you are attaching as I've seen in pictures of the Lemo. I'd suspect that one of the screws cut the coil leg in to resulting in high resistance or open readings. I build my KF's by wrapping the coil leg about 1/2 wrap around the screw and then tightening.

 

[jcglz26]

Hi EBates,

I did like you said, wrapping the coil around the two bolts and keeps doing the same. IDK what else to do... I'm getting frustrated

 

[amnhfz]

i think the screws is not thight, happen to me, but after thighten the screw everything back to normal, again sorry for my bad english

 

[jcglz26]

I just did it for last time and now seems pretty steady...

 

[amnhfz]

I just did it for last time and now seems pretty steady...

btw im using smok m80 for 2 days before decided to sell it, because of the temp control , but if using wattage mode its quite nice mod with 80 watts

 

[jcglz26]

I've heard about the temp control, what's exactly the problem with that? I haven't changed or used that option.

 

[Romano Cheese]

There are tutorials on YouTube of people setting up their Lemo's showing how to trap the leads and wick them