Problems with Mech mod.

[sherman_cj]

I got a Mech mod from zamplebox a couple months ago and now it is starting to stick.

Whenever I go to change my battery or atty my top cap and switch will get stuck (at the same time, not one or the other)

Anyone know what can cause this to happen? Or how to fix this issue?

 

[JBL-37]

Are you over tightening the mod? Try some noalox on the threads and see if that helps.

 

[Bunnykiller]

sounds like you mat need to adjust the pins ( neg or pos) inside the mod to allow a tad more room for the battery...

 

[Kalaniboi81]

Those threads can seize up very easily. I have had this issue in the past with over tightening my atty on my mod. Use a cloth and some channel locks to get it free then clean off the threads and just try not to over tighten in the future, because it can eventually wear out your threads.

 

[Brian Roche]

I have a Bagua (or whatever it's called) that's like that, it'll lock up solid when it warms up from vaping or even just holding. Can't budge the threads with channel locks but eventually I'll just tap the locked ring on the table a few times and it let's go like nothin

 

[sherman_cj]

Thanks for the help everyone I will try these out and see if it fixes my problem.

 

[sherman_cj]

The pins are screwed all the way down on both ends.

sounds like you mat need to adjust the pins ( neg or pos) inside the mod to allow a tad more room for the battery...

 

[sherman_cj]

I will give this a try when I get off work.

Are you over tightening the mod? Try some noalox on the threads and see if that helps.