Problems with USB Passthrough for 801

[agga40s]

I've now ordered 5 USB passthroughs for my DSE 801. The first one lasted about a week - I loved it! When it gave up the ghost, I figured it was because the wiring is so fragile and I hadn't been super careful with it. Ordered 3 more (one for each computer and an extra). Used the charger that plugs into the wall. Those three each lasted two days or less. I just ordered one more...this is the last try. I really enjoyed that first one and keep trying to figure out what I'm doing wrong.

BTW, the button fell off two of them within 24 hours. I could try sending them back, but I ordered from China and if they're just bad in general, it seems a lot of trouble and expense just so I can get even more inferior product.

Is it me, or is it the passthrough? Any ideas?

 

[chris2650]

I got one auto from bestecig, works fine since July, one manual from Rocky mountain that died after 5min, they sent me a replacement wich works fine since FR...but yes, be carefull with those cables, they are not really made for much "bending"....

Just my $0.02

Chris

 

[sattec]

put a small square of paper towel under the button, that will firm it up and stop it from slidding around so much...worked for me!

 

[Applejackson]

Get the Puresmoker passthrough. It's amazing. I just got mine today. It runs at 5v and is super heavy duty. It's totally changed my perspective on vaping. Yeah, it's $40, but it's 100% worth it in my opinion. I'm pretty sure I have to get one of the high volt battery mods now.

 

[Vapaholic]

ya. 5v vaping is so much better than 3.6v, or 3.7v.