Prometheus not firing on nemesis mod

[jkais3r]

I have an hcigar Prometheus from vape royalty that is finicky on my hcigar nemesis. My nemesis fires all other rbas and rdas perfectly.

It it will occasionally fire, but not enough that I can leave home with just it being along.

Everything is tight. I tighten the atomizer first then tighten firing pin then tighten up the switch in my nemesis.

I just put it on my hcigar sentinel m16 and it fired immediately no playing around with it. Battery voltage is 4.05 on nemesis. Sentinel battery just came off the charger. Put rsst on nemesis and fired perfectly.

So it appears to be a problem with the Prometheus and nemesis.
Any ideas?

 

[steel bender]

Sounds like an issue with the prometheus, do you have anything else you can try using it on?

Edit: Or better yet, check the resistance at the 510 connection first with a multimeter, before trying to fire it again.

 

[jkais3r]

Sounds like an issue with the prometheus, do you have anything else you can try using it on?

Edit: Or better yet, check the resistance at the 510 connection first with a multimeter, before trying to fire it again.

It works on my sentinel m16. Haven't had the issue since I put it on there yesterday. Resistance from hot to ground is 1.2 on each coil, not shorted.
Nemesis fires all other attys perfectly.

 

[steel bender]

Yeah, I missed that in your first post, I'm not very familiar with the prometheus, sorry I wasn't any help...

 

[ImThatGuy]

Sounds like it's not making a good connection. Check the posts to see if it's a solid connection.

Adjust the prometheus pin. It is adjustable.

 

[jkais3r]

Adjust the prometheus pin. It is adjustable.

I think that may have solved the problem.. I hate that the adjustable pin screws are loose when you have them adjusted though. I always feel like my mod will just fall apart and juice will be everywhere when I loosen them.

 

[JD1]

I think that may have solved the problem.. I hate that the adjustable pin screws are loose when you have them adjusted though. I always feel like my mod will just fall apart and juice will be everywhere when I loosen them.

Once you tighten the top pin of the neme it should press the threads of the adjustable pin tight and make a good connection though. That's quite a bit of surface area and I wouldn't think there would be much difference from a solid connection.