Prometheus setup. Ideas needed!

[BuzzKilla]

a needle syringe, and some plastic/rubber tubing did the trick.... Looks kinda funky, and made it a breeze to fill with normal juice bottles.
but i had better "pocket" results with a hollow wick and a plugged hole.

But this was all on a single wick setup.
i didn't have too much experiment time with my turbine to see if these methods were good on a dual wick.

So post up what you end up doing and let us know how it works out for you.

 

[pmuniz10920]

Just ordered some stuff, as soon as I build it I will let you guys know.

 

[good_apollo]

Does anybody know if you can get a replacement 510 pin for this atty? I bought it today and tried a few coils on it with just cotton and got nothing but just awful flavor. The coils glowed just fine, it produced a bunch of vapor, but it was awful. Anyhow, I took it apart to clean it to see if that helped and lost the screw that is in the center on the bottom.

 

[pmuniz10920]

Does anybody know if you can get a replacement 510 pin for this atty? I bought it today and tried a few coils on it with just cotton and got nothing but just awful flavor. The coils glowed just fine, it produced a bunch of vapor, but it was awful. Anyhow, I took it apart to clean it to see if that helped and lost the screw that is in the center on the bottom.

No clue, I was wondering the same thing about the positive top screw.

Also I just got 3mm ekowool, ss rope, and ss mesh 400.

 

[pmuniz10920]

Does anyone know the best way to cut SS rope?

 

[good_apollo]

No clue, I was wondering the same thing about the positive top screw.

Also I just got 3mm ekowool, ss rope, and ss mesh 400.

.......n dog must have picked it up off of the floor as soon as i dropped it, i found it 50ft away in the bedroom. good news is i found it, bad news is i found out i suck at building gennys. oh well, back to the fogger and taifun. i'm done with these.

 

[pmuniz10920]

The ss rope and ekowool was a PITA to setup. It also doesn't seem to wick fast enough. I'm gonna try an ekowool only setup and a SS mesh setup.

Has anyone tried XC-116?

 

[VapinBill]

So I got a Prometheus, I need some ideas I have never built a genesis type setup.

I have made 1 change to it, glass tube is so much better than the plastic.

thanks

Where did you get your glass tank ?

 

[pmuniz10920]

Where did you get your glass tank ?

I had IBT cut them for me... I think it was 20mm ODx 1.8mm thick and 16mm tall

 

[pmuniz10920]

Update... So far the best results have been from #400 mesh rolled inside 3mm ekowool. With 4/3 wrap of 28ga kanthal. It's working pretty awesome.